NEW Applications

Product Range

LANSwitch 5-port Ethernet Switch for PC/104+

General EnquiriesTechnical Support
Sahre This Get our newsletter
The AMP LANSwitch is an industry standard multiport Ethernet switch on the PC/104+ form factor. The LANSwitch features a five port 10/100Mbit switch with four external cable connections plus a wired connection to an on-board PCI Ethernet controller.

Unlike an Ethernet hub which broadcasts all messages out of every port, the LANSwitch automatically detects and records where each Ethernet device is located and routes data direct to the appropriate port. This direct wire-speed switching eliminates data collision, significantly reduces unnecessary network traffic and can result in deterministic communications with attached Ethernet devices.

The LANSwitch requires no additional software to support the Ethernet switch and the on board ethernet controller is natively supported by most major operating systems (Windows/Linux/QNX).



  • 5-port 10/100Mbit Ethernet switching
  • Compliant with IEEE802.3/802.3u auto-negotiation
  • Integral PCI 10/100Mbit Ethernet Controller
  • Compact PC/104+ Card
  • Single +5V operation
  • Drivers for Win95/98/NT/2000, Linux, QNX, etc
  • Compact 3.6 x 3.8in PC/104+ form factor

Ethernet Controller

  • 10/100Mbit Ethernet Controller on PCI bus connected to internal port of switch

PC/104plus bus

  • Compliant with PCI Rev 2.2
  • 132MBytes/sec bandwidth at 33.33MHz bus speed
  • PCI Bus Master/Slave

Host System Requirement

  • PC/104plus bus with one spare REQ/GNT
  • +5V or +3.3V signalling

Ethernet Switch

  • 4 External Ports (to RJ45), 1 Internal Port
  • 4 RJ45 sockets
  • 10/100 MBit wire-speed switching
  • IEEE 802.3u auto-negotiation
  • Half/full duplex operation
  • Power saving modes


  • Single +5V power at less than 700mA
  • Operating Temp 0C to 60C (Std) or -40C to +85C (Ext)


  • Ethernet Controller Directly supported by all major OS including Windows/Linux
  • Ethernet Switch No external software required


The following order codes can be used when ordering the LANSwitch

LANSwitch-1/4S - LANSwitch (0C to 60C)
LANSwitch-1/4S-Ext - LANSwitch (-40C to +85C)

Please complete the form below for further information (* - Required).


  captcha image
Webrex Web Design